instruction manual - Hangar 9

Section 12: Installing The Engine
❑ 5. Remove the engine and mounts and drill four 1/8”
holes through the fuselage where marked.
❑ 7.
CONTINUED
Place the engine and the motor mounts in the desired
position. It is helpful to have the prop and spinner
installed at this time to check the clearance. Using a
pencil, carefully mark the engine mount through the
holes in the engine mount flange. Remove the engine
and drill four 1/8” holes where marked.
❑ 6.
Place the motor mounts back into the fuselage and
fasten them into place with four of the screws, washers,
and nuts provided.
❑ 8.
Secure the engine in place using the four remaining
screws, nuts, and washers.
28