instruction manual - Hangar 9

More documents

Recommendations

Info

Section 6: Installing The Nose Gear Parts Needed Nose Gear Wheel (1) Spring Wheel Collar with Screws (2) Steering Arm Tools Needed #2 Phillips Screwdriver Thread Lock ❑ 1. The nose gear mount is pre-assembled onto the front firewall of the fuselage. Locate the nose gear. On the straight end, first slide the steering arm onto the nose gear (note the orientation as shown in the photo). Use thread lock and a #2 Phillips screwdriver to secure the steering arm in place. Next, install a collar and secure it in place with the thread lock and a machine screw. Now slide the spring into position. ❑ 3. Attach the nose wheel and hold it in place using a wheel collar and screw. ❑ 2. Insert the nose gear assembly from Step 1 into the nose gear mount (attached to the front of the fuselage). Be sure the spring stays in position and rests against the nose gear mount. Install the collar on the top end of the landing gear flush with the landing gear, and secure it into position with a screw and the thread lock. 18
Section 7: Installing The Wing Dowels Parts Needed Fuselage Wing Dowels (2) Tools Needed CA Remover Hobby Knife Paper Towel Thin Instant CA Glue ❑ 1. Using a sharp hobby knife, carefully cut the covering around the four holes as shown, leaving a circle that the dowel will be pressed into. ❑ 2. Install the two dowels and position them so that an equal amount of dowel extends from each side of the fuselage. Using thin CA glue, apply five drops around each side of the wing dowel (4 places) where the dowel touches the fuselage. ❑ 3. If necessary, use a paper towel and CA remover to wipe off any excess CA glue. 19
Page 1 and 2: TM HANGAR 9 INSTRUCTION MANUAL Spec
Page 3 and 4: Table Of Contents Introduction 3 Co
Page 5 and 6: Contents Of Kit B E C D A A. Fusela
Page 7 and 8: Field Equipment Required HAN3000 -
Page 9 and 10: Section 1: Assembling The Wings Par
Page 11 and 12: Section 2: Joining The Wing Halves
Page 13 and 14: Section 3: Hinging The Rudder And E
Page 15 and 16: Section 4: Installing The Aileron S
Page 17: Section 5: Assembling The Fuselage
Page 21 and 22: Section 8: Assembling The Fuel Tank
Page 23 and 24: Section 10: Installing The Control
Page 25 and 26: Section 11: Installing The Horizont
Page 27 and 28: Section 12: Installing The Engine P
Page 29 and 30: Section 12: Installing The Engine C
Page 31 and 32: Section 13: Installing The Radio In
Page 33 and 34: Section 14: Installing The Linkages
Page 39 and 40: Section 15: Setting Up The Radio Pa
Page 41 and 42: Pre-Flight Check ❑ 1. Check that
Page 43 and 44: Flight Instructions For first time
Page 45 and 46: Glossary Adverse Yaw. Some airplane
Page 48 and 49: ELEVATOR THROW GAUGE EASY FLY 40 HI

instruction manual - Hangar 9

Create successful ePaper yourself

Delete template?

Save as template?