instruction manual - Hangar 9

Section 4: Installing The Aileron Servo Trays
Parts Needed
Aileron Servo Trays (2)
Wing Center Section Tape
Tools Needed
Clips (e.g., clothespins,
binder clips) (4)
5-Minute Epoxy
Hobby Knife
Masking Tape
Paper Towels
Pencil
Ruler
❑ 1.
Mix a small amount of 5-minute epoxy as per the
instructions included with the epoxy. Remember, once
this epoxy is mixed, you have only 5 minutes of
working time until it dries.
❑ 4.
Using a ruler, measure the distance on the bottom of
the wing at the center line 5-1/2 inches from the trailing
edge and mark with a pencil.
❑ 2.
Spread a thin layer of epoxy over the entire surface of
one side of an aileron tray.
❑ 5.
Next, measure 3-3/4 inches from the leading edge back
to the center line and mark with a pencil.
❑ 3.
Join the two aileron trays as shown and clamp them
together using four clips. Be sure the two trays are
properly aligned. Wipe off any excess epoxy with a
paper towel and set aside to dry for 15 minutes.
14