instruction manual - Hangar 9
instruction manual - Hangar 9
instruction manual - Hangar 9
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Section 14: Installing The Linkages<br />
Parts Needed<br />
Tools Needed<br />
Aileron Horn (2)<br />
Balsa Dowel (2)<br />
Fuselage and Wing<br />
Heat Shrink Tubing<br />
1/16” Plain Rod, Long (2)<br />
1/16” Plain Rod, Short (2)<br />
Plastic Clevis (4)<br />
1/16” Threaded Rod (4)<br />
Drill with 1/16“ Drill Bit<br />
Heat Gun<br />
Hobby Knife or Scissors<br />
Needle Nose Pliers<br />
Thick CA Glue<br />
Z-Bender Pliers<br />
Installing the Aileron Linkage<br />
❑ 3.<br />
Select an X servo horn and trim the long arms off as<br />
shown.<br />
❑ 1.<br />
Locate the wing, two aileron horns, two threaded rods,<br />
and two clevis. Using the Z-Bender pliers, make a z-<br />
bend 4-1/8 inches from the threaded end of both rods<br />
and cut off the extra length of rod.<br />
❑ 4.<br />
Install the servo horn on the aileron servo, as shown.<br />
Install the z-bends in the second, outermost hole from<br />
the center of the servo horn, as shown.<br />
❑ 2.<br />
Screw a clevis onto the threaded portion of both rods.<br />
33