instruction manual - Hangar 9

More documents

Recommendations

Info

Section 13: Installing The Radio Installing the Switch CONTINUED ❑ 1. The switch should be mounted on the left side of the fuselage, away from the exhaust gases. Place the switch plate against the side of the fuselage, as shown, and mark the position of the holes and square. ❑ 2. Using a sharp hobby knife, cut out the marked area and drill holes to allow the switch to be mounted. Mount the switch using the hardware provided. 32
Section 14: Installing The Linkages Parts Needed Tools Needed Aileron Horn (2) Balsa Dowel (2) Fuselage and Wing Heat Shrink Tubing 1/16” Plain Rod, Long (2) 1/16” Plain Rod, Short (2) Plastic Clevis (4) 1/16” Threaded Rod (4) Drill with 1/16“ Drill Bit Heat Gun Hobby Knife or Scissors Needle Nose Pliers Thick CA Glue Z-Bender Pliers Installing the Aileron Linkage ❑ 3. Select an X servo horn and trim the long arms off as shown. ❑ 1. Locate the wing, two aileron horns, two threaded rods, and two clevis. Using the Z-Bender pliers, make a z- bend 4-1/8 inches from the threaded end of both rods and cut off the extra length of rod. ❑ 4. Install the servo horn on the aileron servo, as shown. Install the z-bends in the second, outermost hole from the center of the servo horn, as shown. ❑ 2. Screw a clevis onto the threaded portion of both rods. 33
Page 1 and 2: TM HANGAR 9 INSTRUCTION MANUAL Spec
Page 3 and 4: Table Of Contents Introduction 3 Co
Page 5 and 6: Contents Of Kit B E C D A A. Fusela
Page 7 and 8: Field Equipment Required HAN3000 -
Page 9 and 10: Section 1: Assembling The Wings Par
Page 11 and 12: Section 2: Joining The Wing Halves
Page 13 and 14: Section 3: Hinging The Rudder And E
Page 15 and 16: Section 4: Installing The Aileron S
Page 17 and 18: Section 5: Assembling The Fuselage
Page 19 and 20: Section 7: Installing The Wing Dowe
Page 21 and 22: Section 8: Assembling The Fuel Tank
Page 23 and 24: Section 10: Installing The Control
Page 25 and 26: Section 11: Installing The Horizont
Page 27 and 28: Section 12: Installing The Engine P
Page 29 and 30: Section 12: Installing The Engine C
Page 31: Section 13: Installing The Radio In
Page 35 and 36: Section 14: Installing The Linkages
Page 37 and 38: Section 14: Installing The Linkages
Page 39 and 40: Section 15: Setting Up The Radio Pa
Page 41 and 42: Pre-Flight Check ❑ 1. Check that
Page 43 and 44: Flight Instructions For first time
Page 45 and 46: Glossary Adverse Yaw. Some airplane
Page 48 and 49: ELEVATOR THROW GAUGE EASY FLY 40 HI

instruction manual - Hangar 9

Create successful ePaper yourself

Delete template?

Save as template?