instruction manual - Hangar 9

More documents

Recommendations

Info

Section 14: Installing The Linkages ❑ 7. Locate the short plain rod and insert the 90-degree angle into the opposite end of the balsa dowel. Using thick CA glue, adhere and heat shrink it into place. Installing the Pushrods ❑ 1. CONTINUED Insert one of the pushrods, threaded rod first, into the tail of the fuselage so that the threaded rod exits the rudder pushrod exit hole. ❑ 8. Repeat Steps 5-7 to complete the other pushrod. ❑ 2. Screw on a clevis for 20 full turns. Fasten the clevis in the third hold from the inside of the rudder control horn. 36
Section 14: Installing The Linkages ❑ 3. Center the rudder and the rudder servo so that the servo arm is perpendicular to the fuselage. Mark the plain rod where it crosses the holes in the servo horn. Using Z-Bender pliers, make a z-bend at the marked location and cut off the excess plain rod. ❑ 5. CONTINUED Use the same procedure to install the elevator pushrod, noting that the elevator pushrod exits the rear opening of the fuselage. ❑ 4. Insert the z-bend in the second hole out on the servo horn. Center the servo so that the horn is exactly perpendicular to the fuselage and adjust the clevis on the rudder horn by screwing it in or out until the rudder is exactly neutral when the servo is centered. ❑ 6. The two remaining long plain rods are for the throttle and nose wheel linkage. Using a sharp knife, cut out the opening just behind the nose wheel where the nose wheel pushrod exits. 37
Page 1 and 2: TM HANGAR 9 INSTRUCTION MANUAL Spec
Page 3 and 4: Table Of Contents Introduction 3 Co
Page 5 and 6: Contents Of Kit B E C D A A. Fusela
Page 7 and 8: Field Equipment Required HAN3000 -
Page 9 and 10: Section 1: Assembling The Wings Par
Page 11 and 12: Section 2: Joining The Wing Halves
Page 13 and 14: Section 3: Hinging The Rudder And E
Page 15 and 16: Section 4: Installing The Aileron S
Page 17 and 18: Section 5: Assembling The Fuselage
Page 19 and 20: Section 7: Installing The Wing Dowe
Page 21 and 22: Section 8: Assembling The Fuel Tank
Page 23 and 24: Section 10: Installing The Control
Page 25 and 26: Section 11: Installing The Horizont
Page 27 and 28: Section 12: Installing The Engine P
Page 29 and 30: Section 12: Installing The Engine C
Page 31 and 32: Section 13: Installing The Radio In
Page 33 and 34: Section 14: Installing The Linkages
Page 35: Section 14: Installing The Linkages
Page 39 and 40: Section 15: Setting Up The Radio Pa
Page 41 and 42: Pre-Flight Check ❑ 1. Check that
Page 43 and 44: Flight Instructions For first time
Page 45 and 46: Glossary Adverse Yaw. Some airplane
Page 48 and 49: ELEVATOR THROW GAUGE EASY FLY 40 HI

instruction manual - Hangar 9

Create successful ePaper yourself

Delete template?

Save as template?