instruction manual - Hangar 9
instruction manual - Hangar 9
instruction manual - Hangar 9
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Section 14: Installing The Linkages<br />
❑ 3.<br />
Drill four 1/16” holes through the balsa dowel at the<br />
marks, as shown.<br />
❑ 5.<br />
CONTINUED<br />
Locate one balsa dowel and insert the 90-degree end of<br />
one threaded rod into the previously drilled 1/16” hole.<br />
Cover the portion of the rod that touches the dowel with<br />
thick CA glue.<br />
❑ 4.<br />
Locate the two remaining threaded rods. Using a pair of<br />
needle nose pliers, bend a 90-degree angle 1/4" from<br />
the unthreaded end of the rod. Repeat this procedure for<br />
the other rod. Now locate the two short plain rods.<br />
Using needle nose pliers bend a 90-degree angle 1/4”<br />
from one end of the rods. Repeat this procedure for the<br />
other rod.<br />
❑ 6.<br />
Slide a piece of the heat shrink tubing over the end of<br />
the balsa dowel and shrink it into place using a heat gun.<br />
35