instruction manual - Hangar 9
instruction manual - Hangar 9
instruction manual - Hangar 9
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Section 14: Installing The Linkages<br />
❑ 3.<br />
Center the rudder and the rudder servo so that the servo<br />
arm is perpendicular to the fuselage. Mark the plain<br />
rod where it crosses the holes in the servo horn. Using<br />
Z-Bender pliers, make a z-bend at the marked location<br />
and cut off the excess plain rod.<br />
❑ 5.<br />
CONTINUED<br />
Use the same procedure to install the elevator pushrod,<br />
noting that the elevator pushrod exits the rear opening<br />
of the fuselage.<br />
❑ 4.<br />
Insert the z-bend in the second hole out on the servo<br />
horn. Center the servo so that the horn is exactly<br />
perpendicular to the fuselage and adjust the clevis on<br />
the rudder horn by screwing it in or out until the rudder<br />
is exactly neutral when the servo is centered.<br />
❑ 6.<br />
The two remaining long plain rods are for the throttle<br />
and nose wheel linkage. Using a sharp knife, cut out<br />
the opening just behind the nose wheel where the nose<br />
wheel pushrod exits.<br />
37