instruction manual - Hangar 9
instruction manual - Hangar 9
instruction manual - Hangar 9
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Section 4: Installing The Aileron Servo Trays<br />
CONTINUED<br />
❑ 6.<br />
Unclamp the aileron tray when dry and position it on<br />
the center line so the two marks are visible on the<br />
inside of the aileron tray.<br />
❑ 9.<br />
Carefully remove the covering in the aileron tray area.<br />
This is necessary so that the tray will properly adhere to<br />
the wing.<br />
❑ 7.<br />
Carefully trace around the outside of the aileron tray<br />
using a pencil.<br />
❑ 10. Mix a small amount of 5-minute epoxy and spread it<br />
over the entire area of one side of the servo tray.<br />
❑ 8.<br />
Remove the aileron tray. Using a sharp hobby knife,<br />
carefully cut through the plastic covering. Be careful<br />
not to cut into the wood on the line you just made in<br />
Step 7.<br />
15