IAGC LAND GEOPHYSICAL SAFETY MANUAL Edition 9 ... - CGISS

More documents

Recommendations

Info

5) Company HSE policies.6) Job Descriptions1.5 Safety MeetingsShort tailgate meetings of 5-10 minutes duration should be conducted often, preferablydaily, to discuss accidents, near accidents, as well as unsafe acts or conditions noted bythe crew. Methods of controlling these near accidents should be discussed in order toavoid recurrence. The tailgate meetings should be recorded to highlight gaps in subjectsreviewed, against incident reports.Regularly scheduled, well-organized and properly conducted safety meetings should beheld to discuss new material and subjects not adequately covered at the shortermeetings. A report of these meetings, with attendance records, should be maintained.<strong>IAGC</strong> has extensive safety materials that would be helpful to you in these meetings. It iscommon practice to organize these meetings along the lines of the crew structure, i.e.,drillers, drivers, etc.; crews usually meet separately to discuss subjects specific to theirwork.1.6 Incident ReportingAll accidents, incidents, near misses, hazardous situations, unsafe acts and conditionsshould be reported as per the Company procedures, client or regulatory requirements.Page 10 of 136
All reports should be investigated, reviewed, and actioned in an effort to prevent futureoccurrence of a similar event.1.7 Auditing and ImprovementCrews should be audited on an internal basis to ensure adherence to Companysystems, policies, standards, guidelines, work instructions, and processes. Anydeficiencies or non-conformances should be actioned and corrected as part of aremedial work program.Clients may conduct external audits to ensure compliance with their ManagementSystem requirements.Page 11 of 136
Page 1 and 2: IAGC LAND GEOPHYSICAL SAFETYMANUAL(
Page 3 and 4: 2.20 Respirators...................
Page 5 and 6: 8.1.6 Containers ..................
Page 7 and 8: Additional copies of the manual can
Page 9: 1. INTRODUCTION1.1 PurposeSeismic o
Page 13 and 14: 2. HUMAN BEHAVIOR AND HEALTHHUMAN B
Page 15 and 16: TOFS was developed in a drilling en
Page 17 and 18: take small quantities at frequent i
Page 19 and 20: 3) Mosquitoes are most active after
Page 21 and 22: 1) Reduce the physical demands of w
Page 23 and 24: 2.7 Hazards of NatureA site-specifi
Page 26 and 27: seams are on a level with the top o
Page 28 and 29: 2.15 ArcheologicalDisturbing an arc
Page 30 and 31: metal or polyethylene. An automatic
Page 32 and 33: Install a fully charged and inspect
Page 34 and 35: 3.SEISMIC LINEPage 34 of 136
Page 36 and 37: 1) Orientation. Immediately upon jo
Page 38 and 39: when the operation changes. Both th
Page 40 and 41: 7) An emergency response plan for d
Page 42 and 43: 2) Surface blockages on the horizon
Page 44 and 45: point of handling or exposed electr
Page 46 and 47: 3.13.2 Chain Saw OperationsChainsaw
Page 48 and 49: place the guard on the cutter bar b
Page 50 and 51: Page 50 of 136
Page 52 and 53: move at least 30 m (100 ft.) away.
Page 54 and 55: 7) Battery cell vent plugs or caps
Page 56 and 57: The following table lists the physi
Page 58 and 59: temperatures. Exposure to severe dr
Page 60 and 61:
3.17.4 Personal Hygiene1) Bathe as
Page 62 and 63:
3) Never rewarm by massage, exposur
Page 64 and 65:
8) Reflective vests, and rain gear.
Page 66 and 67:
Page 66 of 136
Page 68 and 69:
4. SEISMIC DRILLING4.1 Drilling Ope
Page 70 and 71:
4.1.3 Personal Safety, Safety Equip
Page 72 and 73:
15) Do not attempt to load a flowin
Page 74 and 75:
1) Check props on a daily basis for
Page 76 and 77:
5. ENERGY SOURCE5.1 Explosives5.1.1
Page 78 and 79:
3) Primers and boosters can be stor
Page 80 and 81:
6) From his station, the shooter sh
Page 82 and 83:
5.2 Surface Energy SourcesSafeguard
Page 84 and 85:
5.2.2 Land Air Gun1) The land air g
Page 86 and 87:
6. VEHICLES6.1 GeneralParty Chiefs,
Page 88 and 89:
The following applies to both vehic
Page 90 and 91:
within a safe distance. Use the two
Page 92 and 93:
25) It is easy to make safe driving
Page 94 and 95:
2) The winch cable should be unspoo
Page 96 and 97:
10) When carrying cargo, evenly dis
Page 98 and 99:
7. WATER OPERATIONS7.1 Small Boat O
Page 100 and 101:
13) When using an inflatable small
Page 102 and 103:
9) All personnel not involved in th
Page 104 and 105:
tripping over lines. Handle the hig
Page 106 and 107:
8 CAMPS8.1 Camp Operations8.1.1 Ele
Page 108 and 109:
4) Surface water from rivers and la
Page 110 and 111:
4) The kitchen staff shall report f
Page 112 and 113:
When maintenance is needed on any e
Page 114 and 115:
13) Learn to erect a scaffold from
Page 116 and 117:
1) Cover cracks, holes and openings
Page 118 and 119:
9. AIRCRAFT9.1 Helicopter Operation
Page 120 and 121:
2) Landing areas must be kept clean
Page 122 and 123:
5) Open and close the helicopter do
Page 124 and 125:
1) Each time the helicopter lands a
Page 126 and 127:
to be transported externally and ne
Page 128 and 129:
10. BULLDOZERS AND WOODGATORSEach m
Page 130 and 131:
11.CRANES AND LIFTING DEVICESPage 1
Page 132 and 133:
2) The operator should examine the
Page 134 and 135:
5) Know how much weight you are lif
Page 136:
13. ACKNOWLEDGMENTSThis nineth edit
show all

IAGC LAND GEOPHYSICAL SAFETY MANUAL Edition 9 ... - CGISS

Create successful ePaper yourself

Delete template?

Save as template?