IAGC LAND GEOPHYSICAL SAFETY MANUAL Edition 9 ... - CGISS

3) Inspections should be conducted prior to daily operations. This inspection shouldinclude -- but not be limited to -- tires, brakes, all fluid levels, steering, back upalarms, hoses and a walk around before moving the vehicle.4) Use foot steps and hand rails while entering or exiting your vibrator. Never jumpfrom the cab to the ground. Ensure the walking area on the back deck of thevibrator is covered with a non-slip surface.5) A vibrator (buggy or truck) normally has a high center of gravity and goodjudgment should be exercised when in rough terrain.6) Due to the size and configuration of these vehicles, special attention should begiven to stopping, following, turning and overall speed. Follow other vehicles at asafe distance in case of an emergency stop.7) Hearing protection should be provided and worn when working close to anoperating vibrator.8) Do not leave the unit pressured up and unattended.9) Be careful when walking or standing near a working vibrator. The vibrator worksrapidly and the operator’s attention may not be directed ahead at all times. Onslopes, the vibrator tends to slide or to vibrate slightly downslope, especially onmud, ice, or snow.10) Do not attempt repairs or maintenance while the hydraulic system is pressuredup. Repair any hydraulic leaks immediately.11) Do not place any part of body under the pad.12) Do not raise the vibrator to change tires or make repairs unless the axles areblocked or cribbed.13) Use only dry nitrogen to charge accumulators. Be extremely careful that oxygenor compressed gases are not mistakenly used. Each compressed gas bottleshould be clearly and legibly marked as to its contents.14) Clean up all oil spills immediately with spill kits or similar materials.Page 83 of 136