Catalog 08-2001 without prices - nl3prc

EASYLOG - Remote Operation Systemfor EASYLOG - dataloggersBy using the software GSOT40K V7.0 in addtion to the local control of loggers connected at Your work place or laptop computer, theycan be operated remotely covering large distances. This is made possible by using MODEMs and conventional or mobile telephonenets. The loggers can be directly connected to the EASYBUS MODEMs just by using a level converter, no additional PC is needed!The following low cost system is sufficient already:working place:GSOT40K at PC &standard modemtelephone lineremote location:with industry modemMODEM 1000 andEASYBUS levelconverter (e.g. EBW1)When performing 'connect loggers' with GSOT40K either a local serial interface connection or a telphone connection will beopened. The read out of the loggers take just a few more time than usually via a local connection, the full range of loggeroperations are possible.Supported are analog MODEMs, which also may be connected to ISDN nets via a suitable terminal adapter.The MODEM of the remote location is a EASYBUS - taylored industry MODEM (MODEM 1000, MODEM 2000 HS, MODEM 3000 GSM),the local MODEM at the GSOT40K working place may be any commonly used modem or one of the MODEMs mentioned above.Extended system with SMS alarm functionAs a special feature an alarm message may be sent to your mobile phone (SMS) when using e.g. an EB2000 MC as levelconverter (MODEM 2000 HS or MODEM 3000 GSM required for SMS).or example an alarm message is sent if a selectable temperature range is exceeded.Alarm by SMSmessageworking place:GSOT40Kmit Standardmodemtelephone lineremote location:withMODEM 2000 HSand EB 2000 MCOne or two relais alarm outputs of the EB2000 are connected to the alarm input of the MODEM. In case of an alarm thepresetable alarm message is sent as SMS message to the mobile phone. When then message was received the operator maye.g. connect to the remote location by using GSOT40K to take a closer look on what is going on. Presently supported mailsystems: D1, D2 and E.Remote operation via mobile telephone nets (900MHz)If there isn't any telephone connection available at the remote location, or if it is a mobile system, it is possible to use the mobileGSM-MODEM. The MODEM 3000 GSM e.g. supports 900MHz mobile telephone nets and is aprooved for european use. It workslike a mobile phone with integrated MODEM. Common SIM cards are supported. It just to be made sure that data transfer isunlocked by the mobile net provider.Your advantagesWith the EASYBUS remote operation system any number of remote locations can be controlled from a single working place.Expensive journeys over hundreds of kilometers aren't necesary any more for the most of the cases, all necssary information isavailable directly at the working place.Installation and putting into operation is as easy as possible. The operation of GSOT40K is basically the same as it used to bebefore. The comfortable configuration software MODKonfig (in scope of supply of GSOT40K) gives a maximum help whensetting up your industry MODEM - without necessary previous knowledge about remote data transfer.With this powerful tools You are enabled to setup the complete reliable system within minutes.67