2 - Big Ass Fans

More documents

Recommendations

Info

8’–24’ POWERFOIL ® X2.0 & 10’–24’ POWERFOIL ® X2.0PLUS FANS22 Installing Guy WiresGuy wires may not be included in your fan order. They are intended to constrain the fan’s lateral movement and areonly included with fans that have extension tubes 4 ft (1.2 m) or greater in length. Depending on the conditions at theinstallation site, guy wires may be needed for fans with shorter tubes to prevent any lateral movement. If guy wires areneeded and were not included with your fan order, contact Big Ass Fans Customer Service at 1-877-BIG-FANS.WARNING: Ensure power is disconnected from the fan before installing the guy wires.AVERTISSEMENT : S’assurer que le ventilateur est hors tension avant d’installer les câbles de retenue.1. Attach locking carabiners to main fan unitAttach the (4) locking carabiners to the guy wire clips on themain fan unit as shown. Securely tighten the carabiners.2. Attach beam clampAttach the beam clamp to the mounting structure. The guy wire shouldaccordingly. Refer to the illustrations on the following page. Fully tightenthe set screw to secure the clamp.Beam ClampabFasten the small eyebolt and nut onto the beam clamp. The nut will be onthe outside of the beam clamp.Loop the guy wire through its crimped end to secure it to the eyebolt asshown.Guy Wire Hardware (BAF-Supplied):a. (4) 1/4” Beam Clampb. (4) 1/4-20 x 1” Eyeboltc. (4) 1/4-20 Hex Nutd. (4) Guy WirecdWWW.BIGASSFANS.COM ©2012 DELTA T CORP. DBA BIG ASS FAN CO. ALL RIGHTS RESERVED
8’–24’ POWERFOIL ® X2.0 & 10’–24’ POWERFOIL ® X2.0PLUS FANSInstalling Guy Wires (cont.)23Note: I-beams are shown in the illustration below. Your mounting structure may differ.Guy WireI-BeamI-BeamGuy Wire45°I-BeamI-BeamI-BeamI-BeamWWW.BIGASSFANS.COM ©2012 DELTA T CORP. DBA BIG ASS FAN CO. ALL RIGHTS RESERVED
Page 3: 8’-24’ POWERFOIL ® X2.0 & 10
Page 6 and 7: 8’-24’ POWERFOIL ® ® X2.0PLU
Page 8 and 9: 8’-24’ POWERFOIL ® X2.0 & 10
Page 13 and 14: Parts and hardware8’-24’ POWERF
Page 15 and 16: Fan diagram8’-24’ POWERFOIL ®
Page 17 and 18: Préparation du lieu de travail8’
Page 29: 8’-24’ POWERFOIL ® X2.0 & 10
Page 39 and 40: Delta secondary8’-24’ POWERFOIL
Page 47 and 48: Wiring: Fan controller with line re
Page 49 and 50: Daisy chaining (cont.)8’-24’ PO
Page 53 and 54: Wiring: Fire signal relay (M series
Page 57 and 58: Understanding and clearing fan faul
Page 59 and 60: Locking and unlocking procedures8
Page 63: Annual Maintenance ChecklistFan Mod
Page 73 and 74: Warranty Claim Form800 Winchester R
Page 75 and 76: Check-In Procedure(for Big Ass 2348
Page 77 and 78: Close-Out Procedure(for Big Ass 234
Page 80:
*002788-01*002788-012348 Innovation
show all

2 - Big Ass Fans

Create successful ePaper yourself

Delete template?

Save as template?