Lighting - Trackspot Manual - SXS Events

Safety CableHigh End Systems strongly recommends that you use safety cablend Audio-Visual Phone: courtesy 0870 of Services 080 2342when mounting any fixture. You must supply your own safety cableand verify the cable is capable of supporting the weight of theTrackspot www.sxsevents.co.ukfixture. You can order galvanized safety cables from yourHigh End Systems dealer/distributor (see “Optional Accessories” onpage Intro-6).mail: enquiries@sxsevents.co.ukClampYou must supply your own clamp(s) and verify the clamp is capable ofsupporting the weight of the Trackspot fixture. You can order deluxeC-clamps for a two-inch truss from your High End Systems dealer/distributor (see “Optional Accessories” on page Intro-6).2Caution: Make sure the fixture cannot be rotated 360°.(Using two clamps is a good way to make surethe fixture cannot be rotated in a full circle.)Allowing the fixture to rotate 360° couldloosen the clamp mounting bolts and causethe fixture to fall from its clamp.Note:Due to the wide variety of possible lighting designs, HighEnd Systems cannot make specific mountingrecommendations. Consider the following procedure as asuggested guideline only.Suggested mounting procedure:1. Unplug the fixture. If the fixture has been operating, allow thefixture to cool for at least 5 minutes.2. Use two people to mount each Trackspot fixture: one person tohold the fixture while it is being secured in place, and one personto the secure the fixture to its support and attach safety cables.3. Always stand on a firm, stable surface when mounting a fixture toits support. The fixture should be at a height where you cancomfortably work on it, and should either be resting on a stablesurface, or held in a stable manner. Do not allow one person toboth support and mount the fixture.4. Attach suitable clamp(s) through the holes on top of the yoke. Ifyou are attaching one clamp, use the middle hole on the yoke. Ifyou are attaching two clamps (as shown in Figure 2-3), attach oneclamp to each of the two outer holes on the yoke. Use lockingwashers when attaching the clamp(s) to the yoke.www.sxsevents.co.ukTrackspot User Manual Mounting the Fixture 2-9