Lighting - Trackspot Manual - SXS Events

More documents

Recommendations

Info

Replacing the Mirror Assemblynd Audio-Visual Phone: courtesyCaution: Use0870cautionofwhenServiceshandling080broken2342glass.!Glass shards are extremely sharp.mail: enquiries@sxsevents.co.ukwww.sxsevents.co.ukYou will need:• replacement mirror assembly (p/n 80180001) (see Figure 3-7)• leather gloves• 7/64-inch allen wrenchTo replace the mirror assembly:1. Unplug the fixture.2. Put on your leather gloves.3. Use a 7/64-inch allen wrench to remove thetwo allen screws that secure the mirrorassembly to the motor (see Figure 3-8). Setthe screws aside.4. Remove the old mirror assembly and carefullydiscard the broken glass.5. Open the boxcontaining the newmirror and carefullyremove the mirrorassembly from its foampackaging.6. Place the new mirrorassembly over thespring plunger andmotor shaft. Align thescrew holes on the newmirror assembly withthe screw holes on themotor. Replace the twoallen screws. Use theallen wrench to tightenthese screws securely.motorallenscrewsmirrorassemblyspring plungerFigure 3-7.Mirror assemblymotor shaftFigure 3-8. Installing a new mirrorCaution:You must tighten the two allen screws firmly.The mirror assembly may fall from the fixtureif it is not secured.www.sxsevents.co.uk3-6 Replacing Parts Trackspot User Manual
Replacing or Installing Custom Gobosnd Audio-Visual Phone: courtesyCaution:0870If the fixtureofhasServices 080been operating,2342allow thefixture at least 5 minutes to cool beforemail: enquiries@sxsevents.co.ukwww.sxsevents.co.ukhandling.The Trackspot gobo wheel includes one open position for a customgobo patterns. This allows you to install any gobo pattern you choose.(An optional gobo wheel with nine open positions for custom gobos(p/n 99110017) is also available from your High End Systems dealer/distributor.)The recommended custom goboshould be made of stainless steeland have a single notch on theedge for easy installation (seeFigure 3-9). The custom goboshould be between 0.1mm (0.004inches) and 0.3mm (0.012 inches)thick with a diameter of 25mm(0.984 inches).3To install a gobo:Figure 3-9. Custom gobo1. Unplug the fixture. If the fixture has been operating, allow thefixture to cool as described above.2. Turn the fixture over so you can easily access its underside.3. Remove the fixture’s access door by sliding the thumb latch towardthe rear of the fixture and lifting the door off.The access door is connected to the fixture by a safety cable. Youcan leave the door attached, or you can unclip the safety cables tocompletely remove the door from the fixture.4. Locate the gobo wheel and gobo wheel sensor (see Figure 3-10).Handle the gobo wheel carefully. If you accidently bend the gobowheel, it may rub against and damage the sensor. If the wheel isrubbing against the sensor or any other internal component, see“Adjusting Wheel Clearance” on page 3-12.www.sxsevents.co.ukTrackspot User Manual Replacing Parts 3-7
Page 1 and 2: nd Audio-Visual Phone: courtesy 087
Page 5 and 6: Declaration of Conformityaccording
Page 7 and 8: dealer or distributor. If purchase
Page 9 and 10: Table of Contentsnd Audio-Visual Ph
Page 11 and 12: Appendix B Trackspot ® MSpeed Time
Page 13 and 14: Introductionnd Audio-Visual Phone:
Page 15 and 16: Getting Helpnd Audio-Visual Contact
Page 17 and 18: Environmental Specificationsnd Audi
Page 19 and 20: Chapter 1nd Audio-Visual Setup Phon
Page 21 and 22: 140DA TA INVO LT AGE S EL E CTWARNI
Page 23 and 24: Chapter 2Configuring courtesy Your
Page 25 and 26: DATA INVOLTAGE SELECTWARNING: CHANG
Page 27 and 28: Table 2-3. Personality switch setti
Page 29 and 30: DATA INDATA OUTVOLTAGE SELECTWARNIN
Page 31: Safety CableHigh End Systems strong
Page 34: Linking the Fixturesnd Audio-Visual
Page 42 and 43: 4. Remove the fixture’s access do
Page 44 and 45: Replacing Power Supply Fusesnd Audi
Page 48 and 49: front of fixturend Audio-Visual Pho
Page 50 and 51: Cleaning the Internal Componentsnd
Page 52 and 53: Reinstalling the Color Wheel or Gob
Page 56 and 57: Table 4-1. Symptoms and Solutionsnd
Page 58 and 59: Table 4-1. Symptoms and Solutionsnd
Page 60 and 61: nd Table Audio-Visual Phone: A-1. c
Page 62 and 63: Table A-2. Construct parameters in
Page 64 and 65: Table A-3. Construct parameters in
Page 66 and 67: Table B-1. DMX 512 protocol MSpeed
Page 68 and 69: Table B-1. DMX 512 protocol MSpeed
Page 70 and 71: Phone: 0870 080 2342mail: enquiries
Page 72 and 73: Address Switch Settingsnd Audio-Vis
Page 74 and 75: WARNING: For Continued Protection A
Page 80 and 81: DichroicA dichroic (from Greek, mea
Page 82: MSpeedA means of defining the time

Lighting - Trackspot Manual - SXS Events

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?