Summagraphics D1000 User's Manual - Summa Online

More documents

Recommendations

Info

Page 1 and 2: SUMMAGRAPHICS D1000USER’S MANUALI
Page 6 and 7: 2.5. INTERNAL TEST MENU............
Page 8 and 9: SECTION 1GENERAL INFORMATION1.1. IN
Page 10 and 11: Depth, stand included 870 mm 34.30
Page 12 and 13: Serial : I/O Port connector DB-9PMa
Page 14 and 15: 1.3. CUTTER ACCESSORIES AND CONSUMA
Page 16 and 17: In order to get acquainted with you
Page 18 and 19: 6. Power ON/OFF switch.- This rocke
Page 20 and 21: EARTH CONNECTION!IMPORTANT OPERATIO
Page 22 and 23: FIGURE 1-6BLADE LENGTH ADJUSTMENT4.
Page 24 and 25: After setting the cutting depth and
Page 26 and 27: Depending on the width of the media
Page 28 and 29: It is not necessary to unroll the m
Page 30 and 31: Press the 1 key if you want to load
Page 32 and 33: SECTION 2OPERATION2.1. THE CONTROL
Page 34 and 35: • Press the LEFT or RIGHT jogging
Page 36 and 37: 2.1.8. THE TOOL UP/DOWN KEYThe TOOL
Page 38 and 39: Four different user configurations
Page 40 and 41: FIGURE 2-3 :FLOWCHART SHOWING FACTO
Page 42 and 43: On the LCD, the active pen pressure
Page 44 and 45: The parity setting of your cutter M
Page 46 and 47: 2.5.1. CUT BORDERFIGURE 2-4 :INTERN
Page 48 and 49: CAUTIONThe following test routines
Page 50 and 51: SECTION 3GENERAL INFORMATION3.1. MA
Page 52 and 53: Trademark AcknowledgementsFIGURE 3-
Page 54 and 55:
6. The computer end of the cable mu
Page 56 and 57:
APPENDIX AMEDIA CERTIFICATIONTypes
show all

Summagraphics D1000 User's Manual - Summa Online

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?