Conveyor Chain - Tsubaki

Double Plus Free FlowChainConveyor Set-Up and Maintenance2. Double-Plus Chain with Snap cover.(1) As the snap cover is made of Engineering Plastic,please handle it with care.(2) As there are snap covers for outer link and Innerlink use, ensure that the appropriate one isattached. (Refer to below diagram)(Chain is shipped with snap cover attached)(4) If the snap cover is broken during attachmentplease replace with a new snap cover.(5) Please ensure a sprocket specified for Double PlusChain with Snap Cover is used.(6) The sprocket for use with a snap cover has asmaller outer diameter than the sprocket for usewith no snap cover. Therefore, if the slack becomeslarger it will be easier for the chain to come off thesprocket. Please ensure that take-up is adjusted soas not to surpass maximum slack.Conveying directionSectionBOuter link snap coverInner link snap cover(3) After attaching the special connection link, correctlyattach the outer link snap cover at the cut sectionof the plate. (Refer to below diagram)Outer link snap coverConnection linkOuter linkChain slackChain slackChain size Standard slack (in.) Maximum slack (in.)C20301.002.95C20401.384.13C20501.574.72C2060H1.975.91C2080H2.567.48Based on previously described conveyor design data.Tsubaki of Canada Limited, 1630 Drew Road, Mississauga, ON L5S 1J6 Tel: 905-676-0400 Fax: 905-676-0904 Toll-Free: 800-263-7088 www.tsubaki.ca e-mail: info@tsubaki.caConveyor Chain B125