Conveyor Chain - Tsubaki

Double Plus Free FlowChainDouble Plus chain cutting and connecting methods1. Cutting methodPunchOuter link to be cutPunchFork toolSectionBOuter plateDouble Plus ChainChain viceChain vice (Sold separately RSC V-1)(A) Using a hand grinder, remove the riveted edge of the pin on the outer link to be cut.(B) Put the Double Plus Chain in the chain vice (or similar device) and using a punch strike the pin until the outer plate can beremoved. (For Double Plus with Snap Cover, remove the snap covers of three links around the link to be cut.)(C) Using the fork tool and the chain vice, cutting can also be performed.2. Connecting method(Using the connecting link)(1) Connecting using a spring clip (Sizes of C2060H and under)(A) After inserting the two (2) pins of the connecting link in theinner linkʼs bushing, insert them in the connecting plateʼs holes.Pin notchConnecting plateSpring clipInner linkSpring clip type connecting link(B) Correctly attach the Spring clip to the pin notchesAfter Spring clipis attachedSpring clip(Open end)Chain travel directionPinSpring clip(2) Connecting using a cotter pin (Sizes of C2080H and over)(A) After inserting the two (2) pins of the connecting link in the inner linkʼs bushing, insert them in the connecting plateʼs holes.(B) Insert the cotter pin into the pinʼs hole and open the cotter pin 60°.Connecting plateCotter pinCotter pinConnectingplateInner linkCotter pin type connecting link60°Conveyor Chain B126Tsubaki of Canada Limited, 1630 Drew Road, Mississauga, ON L5S 1J6 Tel: 905-676-0400 Fax: 905-676-0904 Toll-Free: 800-263-7088 www.tsubaki.ca e-mail: info@tsubaki.ca