AutoHelm ST 2000 Plus - Comcast.net

Chapter 4: Installing the Tiller Pilot 37To measure the critical dimensions:1. Clamp the tiller on the boat’s center line.2. Mark dimensions A and B and use masking tape to locate thefixing points.Note: For standard installations, dimension A is measured on thestarboard side of the cockpit. If you need to mount the tiller pilot onthe port side of the cockpit, you can measure dimension A to port.However you will need to reverse the tiller pilot’s operating sensewhen you have completed installation (see page 52).3. Make sure that:• dimensions A and B are at right angles to each other (asshown on the diagram opposite)• the tiller pilot is mounted horizontallyBasic installationAfter establishing control dimensions A and B, you can usuallymount the tiller pilot directly onto the cockpit seat.Mounting socket12.5 mm(0.5 in)Tiller pinD3192-24 Installing the Tiller Pilot