AutoHelm ST 2000 Plus - Comcast.net

More documents

Recommendations

Info

54 ST1000 Plus & ST2000 Plus Tiller Pilots - Owner’s Handbook5 Commissioning the Tiller PilotChecking the wind instrument interfaceIf you have connected the tiller pilot to a wind instrument, check thedata link as follows:1. Press standby and auto together.2. The tiller pilot should display a ‘W’ followed by the lockedheading.If the display continues to show a flashing ‘C’ and the current heading,the tiller pilot is not receiving any wind data. The most likely reason isa cabling error – either open circuit, short circuit or wires reversed.Checking the SeaTalk interfaceIf you have linked the tiller pilot to other instruments or control unitsvia SeaTalk, check the link as follows:1. Press standby.D3270-2D3271-2
Chapter 5: Commissioning the Tiller Pilot 552. Select display illumination level 0 (LAMP 0) on any other SeaTalkinstrument or autopilot control unit.D170-23. The tiller pilot should immediately respond by switching off itsdisplay illumination. If the illumination does not switch off, thereis a cabling fault between the tiller pilot and the instruments orcontrol unit.5 Commissioning the Tiller Pilot5.2 Initial sea trialCAUTION:Failure to carry out the sea trial may result in impaired autopilotperformance on some compass headings.When you have checked that the system is operating correctly, youmust complete a short sea trial to calibrate the compass.The tiller pilot has a built-in calibration capability so you canfine-tune it to suit your boat, its steering system and its dynamicsteering characteristics.As supplied from the factory, the autopilot is calibrated to providesafe, stable control for most boats.• Do not attempt to make any permanent changes to therecommended calibration values until you have completed thesea trial.• You must carry out the initial sea trial in conditions of light windand calm water – so you can assess the autopilot’s performancewithout the influence of strong winds or large waves.
Page 1 and 2:
ST1000 Plus &ST2000 PlusTiller Pilo
Page 3 and 4:
PrefaceiiiContentsChapter 1: Introd
Page 5 and 6:
Chapter 1: Introduction 1Chapter 1:
Page 7 and 8: Chapter 1: Introduction 31.3 About
Page 9 and 10: Part 1:Using theTiller PilotPart 1:
Page 11 and 12: Chapter 2: Using the Tiller Pilot 7
Page 31 and 32: Chapter 3: Maintenance & Fault Find
Page 33 and 34: Chapter 3: Maintenance & Fault Find
Page 35 and 36: Part 2:Installing theTiller PilotPa
Page 37 and 38: Chapter 4: Installing the Tiller Pi
Page 55 and 56: Chapter 5: Commissioning the Tiller
Page 57: Chapter 5: Commissioning the Tiller
Page 65 and 66: Chapter 6: Adjusting Tiller Pilot S
Page 71: ST1000+ and ST2000+tiller drives: s
Page 74 and 75: 70 ST1000 Plus & ST2000 Plus Tiller
Page 76: Factory Service CentersUnited State
show all

AutoHelm ST 2000 Plus - Comcast.net

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?