DTHC-SETUP/INSTALL MANUAL CandCNC

CURRENT SETTINGS BUTTON: Shows the current profile and settings being used by the DTHC.The DTHC uses a real time processor to process the torch volts and send the proper signals toMACH. The processor stores the settings in NVRAM (non-volatile ram) Changing any setting in theSettings Group or the General THC Settings and using OK (closes the window) saves the profile(writes it to the DTHC processor RAM. You must close the window to be able to access the MACHscreen and to move the machine (JOG) or RUN g-code. Cancel cancels any changes you havemade before you exitThe DTHC module “remembers” the settings you used last even if you power everything off. The CutProfile values are sent to the DTHC module (via a serial connection from the PC to the UBOB and upto the DTHC module) The “Current Values are what is in the DTHC memory. Values are transferredwhen you hit OK NOT when they are just displayed. ONLY the CURRENT SETTINGS values arewhat the DTHC uses during cutting. If you pull up a profile and do not transfer it to the DTHC modulePROFILE LIST BOX : Shows a list of all saved profiles. Any profile can be selected and thoseparameters will be transferred to the Current Settings screen. You can Add new Profiles using theAdd button . To delete an entire profile. highlight the profile by clicking on it and hit the DeleteButton. If for any reason the DTHC module has lost communication with MACH the settings onthe screen ARE NOT SAVED to the NVRAM and opening the screen again to display CURRENTSETTINGS will show the old settings. Check to make sure the THC ONLINE LED is on.PAGE 37