DTHC-SETUP/INSTALL MANUAL CandCNC

More documents

Recommendations

Info

RAW ARC VOLTAGEPLASMA UNITTORCH SWITCHDCP Interconnect cableDB9 to <strong>DTHC</strong> SenosrInput connectorDCPWorkpiece ClampGood connection to the workpiece with clamp is essentialfor proper operation of the THCPAGE 52
Page 1 and 2: DTHC-SETUP/INSTALLMANUALREV5JAN 201
Page 4 and 5: PRELIMINARY TESTING THE DTHC MODULE
Page 6: J15TipVoltsWorkclamp+ [POS]L4R7- [N
Page 12 and 13: HYPERTHERM PowerMAX 45Connecting TH
Page 14 and 15: THC SENSOR CARD TESTINGBefore you m
Page 16 and 17: 1. Most plasma units have connectio
Page 18 and 19: INSTALLATION OF CURRENT TRANSFORMER
Page 20 and 21: Workclamp Lead Wire goesthrough Hal
Page 22 and 23: 2. Start MACH3 on the controller PC
Page 24 and 25: DTHC EXPANION MODULE. Locatedabove
Page 26 and 27: PC w/MACH3Grounding practices to re
Page 28 and 29: SETTING UP YOUR Z AXIS FOR AUTOMATI
Page 30 and 31: PAGE 30
Page 32 and 33: MP3000-DTHC Screen SectionThe follo
Page 34 and 35: ALTERNATE SCREEN SET FOR SMART-KUTU
Page 36 and 37: To Adjust PRESET Volts (andheight)
Page 38 and 39: CURRENT SETTINGS BUTTON: Shows the
Page 40 and 41: INFORMATION GROUP:The Information s
Page 42 and 43: TIP SAVER %: This value determines
Page 44 and 45: GENERAL THC SETTINGSThe General THC
Page 46 and 47: FINAL TESTINGDoing a startup test u
Page 48 and 49: Kerf width: Sets the width offset u
Page 50 and 51: 10. Torch oscillates wildly UP andD

DTHC-SETUP/INSTALL MANUAL CandCNC

Create successful ePaper yourself

Delete template?

Save as template?