Symbol LS3408 Product Reference Guide - Miles Data Technologies

8 - 2 Symbol LS3408 Product Reference GuideConnecting to an IBM 468X/469X HostThe scanner connects directly the host.Host Port ConnectorInterface cableFigure 8-1 IBM Direct ConnectionNOTEInterface cables vary depending on configuration. The connectors illustrated in Figure 8-1 are examplesonly. The connectors may be different than those illustrated, but the steps to connect the scanner are thesame.1. Connect the modular connector of the IBM 46XX interface cable to the cable interface port on the scanner.(See Installing the Interface Cable on page 1-3.)2. Connect the other end of the IBM 46XX interface cable to the appropriate port on the host (typically Port 9).3. Ensure all connections are secure.4. Select the port address by scanning the appropriate bar code from the Port Address section on page 8-4.5. To modify any other parameter options, scan the appropriate bar codes in this chapter.NOTEThe only required configuration is the port address. The IBM system controls most other scannerparameters.