Symbol LS3408 Product Reference Guide - Miles Data Technologies

4 - 8 Symbol LS3408 Product Reference GuideAim DurationWhen the scanner is in Level trigger mode (default mode), Aim Duration sets the amount of time the aiming dotdisplays before turning into a scanning beam. This parameter has no affect when the scanner is in either of theTwo Stage trigger modes. See Trigger Mode on page 4-7 for a description of each of the trigger modes.The aim duration is programmable in 0.1 second increments, from 0.0 to 9.9 seconds. The default Aim Duration is0.0 seconds. When set to 0.0 seconds, no aiming pattern appears before a decode session.To set an aim duration, scan the bar code below. Then scan two numeric bar codes in Appendix D, Numeric BarCodes that correspond to the desired aim duration. Enter a leading zero for durations less than 1.0 seconds. Forexample, to set an aim duration of 0.5 seconds, scan the bar code below, followed by the 0 and 5 bar codes. Incase of an error, or to change the selection, scan the Cancel bar code on page D-3.Aim Duration