Installing the BayStack 400-ST1 Cascade Module - CXtec

More documents

Recommendations

Info

Removing/Replacing Adjacent UnitsTo remove/replace adjacent units from an operating stack,complete the following steps (Figure 16):1. Remove the cascade cable from the Cascade A Outconnector at unit 2.Cascade A Out1Unit 1InUnit 2Unit 3Cascade A InUnit 4Unit 52Unit 6Out1 = Base unit2 = Last unitBS0043AFigure 16.Removing Adjacent Units36
2. Remove the cascade cable from the Cascade A Inconnector at unit 5.3. Remove the units (units 3 and 4) and installreplacement units as required.4. Renumber the order of the units for the new stackconfiguration (if desired).You can renumber the unit numbers as described inyour switch’s User Guide.Removing/Replacing Nonadjacent UnitsNote: Remove and replace the units individually toavoid segmenting the stack configuration.To remove/replace nonadjacent units from an operatingstack, complete the following steps (Figure 17):1. Remove the cascade cable from the Cascade A Inconnector at unit 3.2. Remove the cascade cable from the Cascade A Outconnector at unit 3.3. Remove the unit (unit 3) and install thereplacement unit as required.4. Reconnect the cascade cables (removed in steps 1and 2) to unit 3.37
Page 1 and 2: Installing theBayStack 400-ST1Casca
Page 3 and 4: IntroductionThis guide shows how to
Page 5 and 6: You can obtain the latest updates t
Page 7 and 8: If any items are missing or damaged
Page 9 and 10: Cascade A OutCascade A InUnit 11Cas
Page 11 and 12: • Initial installation -- During
Page 13 and 14: • Stack MAC address -- The stack
Page 15 and 16: 1OutUnit 8Unit 7Unit 6Unit 5Unit 4U
Page 17 and 18: 1InUnit 1Unit 2Unit 3Unit 4Unit 5Un
Page 19 and 20: 1Unit 1Cascade A OutCascade A InUni
Page 21 and 22: Installing the 400-ST1 Cascade Modu
Page 23 and 24: BaseUnit SelectCascade A Out Cascad
Page 25 and 26: 5. Set the Unit Select switch for t
Page 27 and 28: . Connect the other end of the casc
Page 29 and 30: 2. Plug the other ends of the AC po
Page 31 and 32: Modifying an Existing StackConfigur
Page 33 and 34: Adding Units to the StackThis secti
Page 35 and 36: 5. Reconnect the cascade cable from
Page 37: 4. Connect a cascade cable from the
Page 41 and 42: Upgrading the Switch FirmwareYour s

Installing the BayStack 400-ST1 Cascade Module - CXtec

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?