Installing the BayStack 400-ST1 Cascade Module - CXtec

More documents

Recommendations

Info

5. Repeat steps 1 to 4 for unit 5.1Unit 1InUnit 2Unit 3Unit 4Unit 52Unit 61 = Base unit2 = Last unitOutBS0044AFigure 17.Removing Nonadjacent Units6. Renumber the order of the units for the new stackconfiguration (if desired).You can renumber the unit numbers as described inyour switch’s User Guide.38
Upgrading the Switch FirmwareYour switch firmware provides a code load facility thatallows you to upgrade the firmware image over any switchport, including any MDA ports.Note: The BayStack 400-ST1 Cascade Module willnot operate with BayStack 450 switches that areconfigured with BayStack 450 software versionsearlier than version V1.1.0. You must upgrade theswitches to BayStack 450 software version V1.1.0 (orlater) before you install the BayStack 400-ST1Cascade Modules.Accessing the Firmware ImagesYou can obtain the firmware image files and the latestupdates to your product documentation, including releasenotes, by visiting the Nortel Networks Web site at thefollowing location:www.support.baynetworks.com/softwareFollow the instructions provided in the Web page to obtainthe firmware image files and release notes. The releasenotes provide instructions for accessing the firmwareimage.39
Page 1 and 2: Installing theBayStack 400-ST1Casca
Page 3 and 4: IntroductionThis guide shows how to
Page 5 and 6: You can obtain the latest updates t
Page 7 and 8: If any items are missing or damaged
Page 9 and 10: Cascade A OutCascade A InUnit 11Cas
Page 11 and 12: • Initial installation -- During
Page 13 and 14: • Stack MAC address -- The stack
Page 15 and 16: 1OutUnit 8Unit 7Unit 6Unit 5Unit 4U
Page 17 and 18: 1InUnit 1Unit 2Unit 3Unit 4Unit 5Un
Page 19 and 20: 1Unit 1Cascade A OutCascade A InUni
Page 21 and 22: Installing the 400-ST1 Cascade Modu
Page 23 and 24: BaseUnit SelectCascade A Out Cascad
Page 25 and 26: 5. Set the Unit Select switch for t
Page 27 and 28: . Connect the other end of the casc
Page 29 and 30: 2. Plug the other ends of the AC po
Page 31 and 32: Modifying an Existing StackConfigur
Page 33 and 34: Adding Units to the StackThis secti
Page 35 and 36: 5. Reconnect the cascade cable from
Page 37 and 38: 4. Connect a cascade cable from the
Page 39: 2. Remove the cascade cable from th

Installing the BayStack 400-ST1 Cascade Module - CXtec

Create successful ePaper yourself

Delete template?

Save as template?