You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
BAG D (Co<strong>nt</strong>inued)Figure 5438 114 115 116 1173810956Step 5. Thread a 3/8" ball stud (38) i<strong>nt</strong>o the outer hole in the right rearhub (112) from the side opposite the letter ('L' and 'R') designating leftand right. Place a "foam thing" (56) over the ball stud (38).Step 6. Press a 3/16" x 3/8" bearing (114) i<strong>nt</strong>o the inside of the rear hub(112). Slide the rear axle (109), from the inside, through the bearing(114).Step 7. Slide the ce<strong>nt</strong>er bearing spacer (115) over the axle and againstthe bearing (114). Slide the second bearing (114) over the axle andpress it i<strong>nt</strong>o the outside of the rear hub (112).Step 8. Place a rear axle spacer (116) over the rear axle, against theoutside bearing (114). The small side of the spacer (116) should bepositioned against the outside bearing (114).Step 9. Secure the rear axle (109) and spacer (116) by pressing a 1/16"x 7/16" pin (117) through the small hole in the rear axle (109). The pin(117) should be ce<strong>nt</strong>ered in the rear axle (109).114117116114115112Figure 54Figure 5531 51 46Step 10. Slide a suspension ball (121) over a 4-40 x 1/2" cap headscrew (31) and thread it i<strong>nt</strong>o the middle shock mou<strong>nt</strong> hole on the rightrear suspension arm (118) from the back side.Step 11. Slide an outer rear hinge pin (51) partially through the outsideof the right rear suspension arm (118) from the rear. Slide a plasticrear hub spacer (120) over the pin (51) and against the rear portion ofthe suspension arm (118).Step 12. Place the right rear hub (112), marked 'R', (ball stud facingrearward) between the outer rails of the suspension arm (118), againstthe spacer (120). Slide the hinge pin (51) partially through the hub(112).Step 13. Insert another rear hub spacer (120) (not shown in Figure 55)between the rear hub (112) and the forward rail of the suspension arm(118). Slide the hinge pin (51) through both sides of the suspensionarm (118), the rear hub (112), and both spacers (120). Secure the hingepin with two 1/8" E-clips (46).Step 14. Repeat Steps 1-13 for the left suspension arm (119) and lefthub (113).121311181125146Figure 5512023
Change language