xxx-nt sport owner! - Losi

ENGINE INSTALLATION (Continued)Figure 80/81169169Step 19. Insert a 4-40 x 1" cap-head screw (169), from the left, througheach of the two holes in the middle of the engine.Step 20. Wet your finger with water and lightly moisten the exhaustport gasket (170) and slide it in place over the exaust port of theengine.Step 21. Position the aluminum exhaust header over the exhaust porton the motor and align the holes in the header flange (171) with thescrews (169). Secure the header (171) to the engine by tightening thetwo screws (169).170Note: Side Exhaust engine shown.171Figure 80/81Figure 82172 173Note: Side Exhaust engine shown.Step 22. Place a countersunk washer (172) over each of the 5-40 x 1/2" flat-head screws.Step 23. Position the engine in the chassis (19) and line up the holesin the engine mounts (164) with the slots in the chassis (19).Step 24. Thread the 5-40 x 1/2" flat-head screw (173), with the washers(172) in place, all the way into each of the four holes in the enginemounts (164). Be sure all the countersunk washers (172) fit downinside the slots in the chassis (19). Do not fully tighten the screwsyet.Tip: It's a good idea to use a thread-lock compound on the threadsof the screws in the engine mounts.19173 1721643 6Figure 82