xxx-nt sport owner! - Losi

RADIO INSTALLATION (Continued)Figure 107Slide Valve Carburetors190Step 30. For slide valve carburetors, you will need to remove theshorter, perpendicular arm of the throttle servo horn (190), as shownin Figure 107. Cut off the arm with heavy duty clippers or a Dremel TMhobby tool.Figure 107Figure 108Step 31. Determine which throttle servo spline insert (200) will fityour throttle servo by referring to the table on page 3, Figure 7C.Step 32. Press the correct throttle servo spline insert (200) into thehexagonal hole in the bottom of the throttle servo horn (190).190200Figure 108Figure 109187 201Step 33. Attach the throttle linkage to the throttle servo horn byinserting a 2-56 x 1/2" button-head screw (187) through the over-rideslider (195) and into the middle hole in the longer arm of the throttleservo horn (190) from the bottom. Once the screw (187) is snug upagainst the over-ride slider (195), unscrew it one full turn to allowsome movement between the arm (190) and the slider (195). Securethe screw (187) with a 2-56 locking nut (201).Step 34. Insert the brake linkage Z-bend (197) from the top, throughthe middle hole in the shorter arm of the throttle servo horn (190).197190201195187Figure 10948