xxx-nt sport owner! - Losi

RADIO INSTALLATIONFigure 90Step 1. Cut a piece of two-sided tape (182) to the same size as thebottom of the receiver. Remove the backing from one side of the tape(182) and attach the tape (182) to the bottom of the receiver.Tip: For best results clean the surfaces that the two-sided tape willbe attached to with a mild rubbing alcohol. This will ensure agood, strong bond. Allow the surface to fully dry before attachingthe tape.Step 2. Remove the backing from the remaining side of the two-sidedtape (182) and attach the receiver to the side of thecenter chassis brace (29), between the two receiver box guide rails asshown. The receiver should be mounted so that it is at least 1/8"above the chassis (19) and the antenna is to the front of the truck.Step 3. Plug the steering servo into the slot marked "Channel 1" or"Function 1" on the receiver.18229Figure 90Figure 91184Step 4. Route the antenna wire up, through the antenna mountingpost in the center chassis brace (29).Step 5. Slide the antenna wire through the antenna tube (183) (a smalldrop of oil in the tube will make this easier).Step 6. While pulling the wire through the antenna tube (183), slidethe antenna tube (183) down and push it firmly into the antennamounting post on the center chassis stiffener (29).Step 7. Fold the wire over the antenna tube (183) and place the antennacap (184) over the tube (183) and extra wire.*NOTE: If the antenna wire is shorter than the tube, remove thetube and cut enough off of the tube so that the wire will extend about3/4" past the end of the tube.18329Figure 9140