xxx-nt sport owner! - Losi

RADIO INSTALLATION (Continued)Figure 100Rotary Valve CarburetorsStep 30. For rotary valve carburetors, you will need to remove thestraight, shorter arm of the throttle servo horn (190), as shown inFigure 100. Cut off the arm with heavy duty clippers or a Dremel TMhobby tool.Figure 100190Figure 101Step 31. Determine which throttle servo spline insert (200) will fityour throttle servo by referring to the table on page 3, Figure 7C.Step 32. Press the correct throttle servo spline insert (200) into thehexagonal hole in the bottom of the throttle servo horn (190).190200Figure 101Figure 102187187 201Step 33. Attach the throttle linkage to the throttle servo horn byinserting a 2-56 x 1/2" button-head screw (187) through the over-rideslider (195) and into the inner hole in the longer arm of the throttleservo horn (190). Once the screw (187) is snug up against the overrideslider (195), unscrew it one full turn to allow some movementbetween the arm (190) and the slider (195). Secure the screw (187) witha 2-56 locking nut (201).Step 34. Insert the brake linkage Z-bend (197) from the bottom, throughthe middle hole in the shorter arm of the throttle servo horn (190).197201195190Figure 10245