You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ENGINE INSTALLATION (Co<strong>nt</strong>inued)Figure 77/78Note: Pull Start engine shown. Rear exhaustengine mou<strong>nt</strong>s the same.16291629Step 12. Place a ball stud washer (9) over the four 4-40 x 1/2" cap-headscrews (31). Insert a 4-40 x 1/2" cap-head screw (31) through the fourholes in the engine as illustrated.Step 13. Attach the engine to the engine mou<strong>nt</strong>s (164) by threadingthe four screws (31) i<strong>nt</strong>o the four holes shown.*NOTE: The two engine mou<strong>nt</strong>s should be positioned with thenarrow end up as shown in Figure 78.Tip: It's a good idea to use a thread-lock compound on the threadsof the screws in the engine mou<strong>nt</strong>s.IMPORTANT NOTE: Make sure that the engine mou<strong>nt</strong>sare installed correctly as indicated in Figure 78. The larger, partiallythreaded holes should be positioned toward the fro<strong>nt</strong> of the motor,and the four screws should be installed i<strong>nt</strong>o the smaller, fully threadedholes.164Figure 77/783 4