xxx-nt sport owner! - Losi

RADIO INSTALLATION (Continued)Rotary Valve CarburetorsIf your engine comes equipped with a rotary valve carburetor, complete the steps in Figure 98 through Figure 104. Ifyour engine comes equipped with a slide valve carburetor, skip ahead to page 47 and complete the steps in Figure 105through Figure 111.Figure 98193193192Step 24. Slide a linkage collar (192) over the end of the throttle Z-bendwire(191) (the shorter of the two), and position it approximately 1/4"(6mm) from the Z-bend. Secure the collar (192) with a 4-40 x 1/8" setscrew (193).Step 25. Place the throttle over-ride spring (194) (longer of the twosprings) over the wire (191) and against the collar (192). Slide a plasticover-ride slider (195) onto the wire (191), so that the long end istowards the Z-bend.Step 26. Place a brake over-ride spring (196) (black, shorter of the twosprings) over the wire (191) and against the over-ride slider (195).Place a linkage collar (192) over the end of the wire (191), so that thesprings are somewhat compressed, and secure it with a 4-40 x 1/8"setscrew (193). The collar (192) should be positioned at the end of thewire (191). Final adjustments will be made later.191194195193196192Figure 98Figure 99193193196193Step 27. Slide a linkage collar (192) over the end of the long, brake Z-bend wire (197), and position it aproximately 2 1/4" (60mm) from the Z-bend. Secure the collar (192) in place with a 4-40 x 1/8" set screw(193).Step 28. Slide a plastic over-ride slider (195) onto the wire (191), sothat the long end is towards the Z-bend. Place a brake override spring(196) (black, shorter of the two springs) over the wire (191) and againstthe slider (195).Step 29. Slide a linkage collar (192) over the end of the wire (191) untilit just touches the spring (196). Secure it with a 4-40 x 1/8" setscrew(193). Once again, final adjustments will be made later.192195197192Figure 9944