Mini-Space Series Installation, Operation & Maintenance Manual

Mini-Space Series Installation, Operation & Maintenance ManualAir Technology Systems, Inc.Frederick, Maryland USA 21704Telephone: (301) 620-2033Facsimile: (301) 620-1396APPENDIX A - FORMSStulz Air Technology Systems Inc.Frederick, Maryland USA 21704Telephone: (301) 620-2033 Facsimile: (301) 620-1396Checklist for Completed Installation❏ 1Proper clearances for service access havebeen maintained around equipment.❏ 12Filter (s) installed (if required).❏ 2Equipment is level and mounting fasteners (ifapplicable) are tight.❏ 13Ductwork completed or optional plenum installed(if required).❏ 3Piping completed to refrigerant or coolant loop(if required).❏ 14Incoming line voltage matches equipmentnominal nameplated rating ± tolerances.❏ 4All fi eld installed piping leak tested.❏ 15Main power wiring connections to the equipment,including earth ground, have beenproperly installed.❏ 5❏ 6Refrigerant charge added (if required).Condensate pump installed (if required).❏ 16Customer supplied main power circuit breaker(HACR type) or fuses have proper ratings forequipment installed.❏ 7Drain line connected.❏ 17All wiring connections are tight.❏ 8❏ 9❏ 10Water supply line connected to humidifier(if required). If manual cut-off valve is installed,open valve.Humidifier “Auto/On/Off/Drain” switch is in“Auto” position.Safety pan installed under ceiling mountedequipment (if required).❏ 18❏ 19Control wiring connections completed toevaporator and condenser/condensing unit(if required), including wiring to wall mountedcontrol panel and optional controls.Foreign materials have been removed frominside and around all equipment installed(shipping materials, construction materials,tools, etc.).❏ 11Filter box installed (if required).(©April, 2008)A-1Air Technology Systems, Inc.