CM 811/812 Operating Instructions Programming Instructions

Operating Instructions CM 811/812 Cash Register Programming Instructions///////////////////////// YOUR RECEIPT // THANK YOU /////////////////////////CLERK 1 PM01-0309-01-2006 0023DEPT01 10.00T1DEPT02 20.00T2- - - - - - - - - - - - - - - - - - - - - - -SUBTTL 30.00VAT 10.000% 0.91T1VAT 20.000% 3.33T2- - - - - - - - - - - - - - - - - - - - - - -TOT EXCL VAT 25.76CASH 10.00CASH 10.00CASH 10.00CHANGE 0.0042 Z-Report Security CodeManagement reports can be printed in either the "X" or "Z" position on the control switch. When printed in the "Z" position,transaction totals are reset to zero. Assigning a security-code can prevent accidental reset of transaction totals. Onceassigned, the "Z" report prints only after entering the security code.42.1 Programming the Z-Report Security CodeNote:Assign a number easily remembered. You should also keep the program receipt as a reminder.If you do target the code, reset this program with a new code. Then, print the using the new code.Example: "6543" is programmed as the new security code.Set the key to PRGEnter the security code as 4 digits.Input Confirm by pressing DisplayConfirm by pressing b 6543 b P SECU CODE 65,4342.2 Entering the Z-Report Security CodeSet the key to ZEnter the security code. Confirm by pressing n.In case that the security code "0000" is preset,enter q key only.Example: Enter security code "6543".Input Display Confirm by pressing6543 65,43 nOlympia 8.2005 Page 43 All Rights Reserved