CM 811/812 Operating Instructions Programming Instructions

Operating Instructions CM 811/812 Cash Register Programming Instructions43 Management Report NotesThis section gives instructions for taking reports. Reports may be taken with the control switch in the X or Z position.• X Position - Reads financial reports.• Z Position - Reads financial reports, and resets totals to zero.The read-out for the financial report is the same whether taken in the X or Z position, the only difference is that totals arereset to zero after a Z position report.43.1 Printing reportsX-reports: Without memory deletion. Z-reports: With memory deletion.Set the key to X (to print X-reports) or Z (to print Z-reports) as necessary.Report type:Day's X and Z-financial reportDay's X and Z-PLU reportX and Z-clerk reportMonthly X2 and Z2 financial reportX and Z-training reportElectronic journal (X)Start printout with:qfQ99q88qpElectronic journal (Z)p(only when active in system option 26)If the full electronic journal should be printed,the message CL appears in the display together with an acoustic signal.− If the electronic journal should be deleted after printing, press g.− If the electronic journal should not be deleted after printing, press S.Delete the electronic journal without printing Input Confirm by pressingSet the key to Z 81 RCL in the display: Delete the electronic journal by pressing g.CL in the display: Do not delete the electronic journal by pressing S.44 Electronic Journal (EJ)44.1 Basic Explain for Electronic JournalThis Electronic Cash Register has 3000 lines for electronic journal memory. Those are used for REG mode transactionand Z financial report. Therefore, the other transaction like X report and programming dump report will not be buffered toelectronic journal memory.Olympia 8.2005 Page 44 All Rights Reserved