Prestige SOLO 110.pdf - Bloom Lake Farms

Unit PreparationsSECTION III - Unit PreparationsHandling InstructionsThe PRESTIGE Solo is generally easier tohandle and maneuver once removed from theshipping carton and pallet.To remove the shipping carton and pallet:CAUTIONUse care not to lift the unit from, or placethe unit on the front plastic controlpanel, damage can occur. Use care not todrop, bump or rotate the boiler upsidedown, as damage to the boiler will result.1. Remove any shipping straps and open theside of the shipping carton.2. Slide the unit with the foam inserts out ofthe carton.3. Discard all packing materials.Wall Mounting InstallationThe PRESTIGE Solo should be wall mountedusing the bracket kit provided with the boiler.The PRESTIGE is not designed for floor installation.If floor installation is required anoptional floor stand is available throughTriangle Tube.WARNINGThe wall used for mounting the PRES-TIGE Solo must be vertically plumbedand capable of supporting a minimum130 pounds [59 Kg]. Failure to complywith these requirements could result inpersonal injury, death or substantialproperty damage.Wall Mounting Guidelines1. The wall-mounting bracket is designed forstud spacing of 12 inch or 16 inch on centers.For unconventional stud spacing, asolid / secure mounting surface must beprovided for installation of the bracket.2. For applications using wood studs, installthe bracket using the lag screws providedwith the boiler. Ensure both lag screws areinstalled securely in the studs.3. For applications using metal studs, installthe bracket to the studs using 3/16” togglebolts and washers.4. DO NOT mount or attempt to mount thewall bracket to hollow sheet rock or lathewalls using anchors. Only install boiler tostuds or equivalent wood structure.5. For applications using solid walls (rock,concrete, brick, cinder block, etc.), installthe wall bracket using anchors (doubleexpansion shields) and bolts with washersprovided with the boiler.6. The boiler is too heavy and bulky for a singleperson to lift and attempt to mount; aminimum of 2 people is required formounting the boiler.WARNINGUse extreme care not to drop the boileror cause bodily injury while lifting ormounting the boiler onto the bracket.Once mounted verify that the boiler issecurely attached to the bracket andwall. Failure to comply with the aboveguidelines could result in property damage,personal injury or death.Wall Bracket Installation - Stud Walls1. Locate the studs in the general area of theboiler placement.2. Place the wall-mounting bracket on thewall centering the mounting slots with thestud centers and ensuring the upper edge ofthe bracket is away from the wall.3. Level the bracket, while maintaining it’scentering with the studs and use a pencil tomark the location of the mounting slots.12