Prestige SOLO 110.pdf - Bloom Lake Farms

Maintenance ProceduresClean Condensate Drain Assembly1. Loosen the slip ring nut from the condensatedrain assembly disconnecting theassembly from the boiler.2. Empty any water from the trap and drainassembly. Flush with fresh water as necessaryto clean.3. Check the drain piping from the condensatedrain assembly to the drain. Flush to cleanas necessary.4. Reassemble the condensate drain assemblyonto the boiler by tightening the slip ringnut with rubber seal onto the boiler. Handtight only.5. Remove the fill plug on the condensate drainassembly and fill with water. See Fig. 15 onpage 26.6. Replace the fill plug on drain assembly.Check Ventilation Air OpeningsVerify that all ventilation openings to themechanical room or building are open andunobstructed. Check the operation and wiringof any automatic ventilation dampers.Check and verify the vent discharge and thecombustion air intake are free of debris andobstructions.Inspect Vent and Combustion Air PipingVisually inspect the venting system and combustionair piping for blockage, deteriorationor leakage. Repair any deficiencies.Verify that the combustion air inlet piping isconnected, sealed and properly supported.WARNINGFailure to inspect the vent system andcombustion air inlet piping and to haveany conditions repaired, can result insevere personal injury or death.Check Boiler SystemVerify all system components are correctlyinstalled and operating correctly.Check the cold fill pressure for the system, typicalcold water fill pressure is 12 psig.Verify the system pressure, as the unit operates athigh temperature, to ensure the pressure does notexceed 25 psig. Excessive pressure reading indicatesexpansion tank sizing is incorrect or systemperformance problems.Inspect air vent and air separators in the system.Remove the caps on automatic air ventsand briefly depress the valve stem to flushvent. Replace the cap when completed. Ensurevents do not leak, replace any leaking vents.60