Prestige SOLO 110.pdf - Bloom Lake Farms

Unit Preparations4. Remove the bracket from the wall and drill1/4” diameter hole by 3” deep positioned inthe center of each mark. For applicationsusing metal studs and 3/16” toggle bolts,drill the required clearance hole.5. Reposition the bracket onto the wall andalign mounting slots/holes. Insert the twolag screws provided (or toggle bolts formetal studs) through the mountingslots/holes and loosely tighten.6. Level bracket and tighten screws (bolts formetal studs) securely making sure not toover-tighten to avoid damaging drywall orplaster.Wall Bracket Installation - Solid Walls1. Locate the general area of the boiler placement.2. Place the wall-mounting bracket on thewall ensuring the upper edge of the bracketis away from the wall.3. Level the bracket and use a pencil to markthe location of the mounting slots on thewall.4. Remove the bracket from the wall and drilla 5/8” diameter hole by 1-3/8” deep positionedin the center of each mark.5. Install the anchors (provided) flush orslightly recessed in the drilled holes withthreaded side facing down.6. Reposition the bracket on the wall andalign mounting slots/holes. Insert the twobolts (provided) through the mountingslots/holes and loosely tighten.7. Level bracket and tighten bolts securely.Boiler Mounting1. Obtain assistance in lifting the boiler ontothe wall bracket.2. Install the boiler making sure the boilermounting lip located along the upper edgeof the rear jacket panel engages the wallmountingbracket. Ensure the boiler isseated properly and is secure.13