Stratos HSSD-2 • INSTALLER'S HANDBOOK

3.4.13 Latching faults (Yes/No - Address 000-127)Setup menu > Alarm actionsWhen this function is set to Yes it requires a reset from the front panel or a remotereset to clear fault indications. This is the factory default setting. It may be applied tothe Command Module or a Standard Detector.3.4.14 Remote day/night (Yes/No - Address 001-127)Setup menu > Alarm actionsSetting this function to Yes allows the detector to be manually switched between dayand night mode using a remote input.3.4.15 Remote reset enable (Yes/No - Address 000-127)Setup menu > Alarm actionsIf remote resetting of the detector or Command Module is required from the host FireAlarm controller or other external source, this option must be set to Yes.3.4.16 Remote Isolate Enable (Yes/No - Address 000-127)Setup menu > Alarm actionsWhen this function is set to Yes a remote switch may be used to isolate the detectoror Command Module.3.4.17 Programmed Isolate (Yes/No - Address 000-127)Setup menu > Alarm actionsWhen set to Yes the controller will not generate alarms and will not indicate afault condition on any fire panel which is connected, e.g. for use during detectormaintenance. The ‘Fault’ light will be illuminated on the detector or Command Modulefront panel. The isolated condition will be disabled automatically after 7 days if notmanually disabled.3.4.18 Detector address / Number of detectors(Display - Address 000-127)Setup menu > DetectorIn the case of the Standard Detector, this function displays the current address ofthe detector as set by the internal DIP switch. On the Command Module, it showsthe number of detectors found on the communications loop. This function appearsimmediately on entering the Detector submenu. The Command Module is alwaysat address ‘000’. When the Command Module unit is fitted in a detector, thedetector must have a separate address.Page 17Stratos HSSD-2 • INSTALLER’S HANDBOOK • Iss. 10© AirSense Technology. 2009