BSL PRO 4 Manual - Biopac

162 BSL PRO ManualTo use one of these control panels:Choose MP UNIT > Output Control and then select Pulses, Stimulator – BSLSTM, or Low VoltageStimulator.Control panel options for Pulses, Stimulator – BSLSTM and Stimulator – Low VoltageAdditional control panel options for Low Voltage StimulatorRight-click in the Output Control panel (or choose File>Preferences and select from the sub-menu) togenerate the Output Preferences dialog.Set the Preferences.General: ON/OFF, Number of pulses, Event options — see page 171Advanced: Pulse width, Pulse repetition (rate) — see page 174Level (low voltage only): Pulse level — see page 177Reference Channel (low voltage only): Channel assignment, signal generation — see page 179Once configured, Preferences may be saved using the Save Settings command, activated by pressing thebutton at the bottom of the Preferences dialog (see page 170).Confirm the settings in the control panel. Adjust as desired within the parameters established in Preferences.Entry limits: Settings entered into the Preferences dialog may establish, or limit, the values in the OutputControl panel entry boxes. You may enter pulse settings directly into the control panel only if parametersestablished in Stimulator Preferences allow. If an entry box is grayed or disabled, its value is set or limited byPreferences.Initiate the pulse sequence as defined in Preferences (see page 171).ON/OFF Button in Output Control Panel uses the switch in the Control panel.Recording uses the Start /Stop button in the data acquisition window.To close an Output Control panel:Right-click anywhere in the Output Control panel to generate a pop-up menu and then choose Close, or selectit (or another output control) from the MP UNIT > Output Control submenu.Visit the online support center at www.biopac.com