Technical Appendix Specifications for the RADIO SYSTEM UPGRADE

Terminating Cross ConnectA. To conserve space in the wall mounted cross connect backboard small "110" or 3 M "BICS"type blocks should be utilized.B. The preferred terminating/cross connect type equipment is the KRONE, INC. LSA-PLUSseries of blocks.C. All terminations must be clearly marked and labeled to allow rapid identification of everycircuit and its termination point to facilitate repair or relocation of equipment.D. To the greatest extent possible, all equipment intercabling and/or cable/wiring bundles shallbe neatly secured by means of plastic tie wraps, secured by surface mounted clamps andhidden from view.ReferencesWithout limiting the generality of other requirements of this Specification, all work specifiedherein shall conform to or exceed the applicable requirements of the referenced Standards;provided that wherever the provisions of listed publications are in conflict with the requirementsspecified herein, the more stringent requirements shall apply unless in conflict with the equipmentmanufacturer’s written recommendations: Title 24 of the California Code of Regulations (CCR; Effective November 1, 2002),which includes:Part 1 - California Building Standards Administrative CodePart 2 - California Building Code (Volumes 1, 2 and 3)Part 3 - California Electrical Code (effective August 1, 2005)Part 6 - California Energy Code (effective October 1, 2005).Part 9 - California Fire CodePart 12 - California Reference Standards CodeCalifornia Essential Services Building Act, Health and Safety Code Chapter 2, Section16000 (includes, but is not limited to nonstructural components such as communicationssystems, power switching equipment, and emergency backup systems) NEC 70 (National Electrical Code) Sections 100-300 and Section 800All pertinent FCC rules and regulations, specifically including 47 CFR Part 90: PrivateLand Mobile Radio; Part 15, Subpart J: Computing Devices; and Part 2, Subpart J, FCCEquipment Authorization Procedures.47 CFR 1.1310 – Radio Frequency Radiation Exposure LimitsProject 25 System & Standard Definitions (TSB102A), and all referenced designdocuments (TSB [Telecommunications Systems Bulletin], IS- [Interim Standard] or TIA[Telecommunication Industry Association Standard]).Uniform Building Code, including the seismic requirements of Section 2312, forEarthquake Zone 4ANSI/TIA/EIA Standards RS 232-C, RS 485, Category 5/5e/6 ANSI/TIA/EIA-568-A/BCity of San Luis Obispo 81 Radio System Upgrade TECHNICAL APPENDIX