SL 4 Manual for Serato Scratch Live 2.2.2 - Juno Records

2 b. Using two control sources:Unassign the USB Source for the non-playingVirtual Deck on Computer A. Then haveComputer B assign that same USB Source toone of its Virtual Decks. See “USB Sources &Analog Inputs” on page 13.Mixing With OneTurntable OrCD PlayerAdditional Setup3. Play a track on this Deck and mix it in whenready—you’ll now have audio from bothcomputers in the mix.4. Fade out the audio playing from the firstcomputer to the audio playing from the secondcomputer.5. When only audio from the second computer isleft in the mix, remove the first computer.6. Assign USB sources for the remaining VirtualDecks on the second computer and continueDJing.This single turntable technique allows you to mixas if you had two turntables, using just one. Ifone of your turntables is not performing properly,or if you only have one available, you will be ableto continue to mix the way you are used to.The following is a step-by-step descriptionof how to perform a mix using only your rightturntable or CDJ with the instant doubles feature.This section covers general preferences andadjustments you can make to improve theperformance of Scratch Live. From the top of themain screen, click on SETUP to get to this area.Menu SettingsGo to the Setup menu, click on the Playbacktab. Make sure Instant doubles is checked, andLock playing deck is unchecked.1. Load a track onto the Right Deck in ScratchLive and play as usual.2. Put the Left Deck into INT mode.3. Load the same song you have playing on theRight Deck onto the Left Deck. The track onthe Left Deck will start playing from the samepoint and at the same pitch as the Right Deck.4. You can now quickly slide your mixer’scrossfader over to the Left Deck.5. Your Right Deck is now free to load up a newsong ready to mix in.6. Repeat!TIP: Instant doubles works with either Deck.See “Lock Playing Deck” on page 32.See “Instant Doubles” on page 33.RANE SL 4 FOR SERATO SCRATCH LIVE • OPERATOR’S MANUAL 2.2.2 31