AXIS 215 PTZ Network Camera User's Manual - IP Way

If Microphone is selected - set the Input sensitivity to:AXIS 215 PTZ - Setup• High if the connected microphone is an ordinary (unamplified) microphone, e.g. a computer mic orclip-on mic.• Low if the connected microphone has a built-in line amplifier.Enable microphone power - microphone power should only be used with an electret microphone without abattery. This setting should not be enabled when using a dynamic or battery powered microphone.Input gain - volume control of the audio input. The Input sensitivity levels High and Low are volume settingsmade earlier in the audio path (see above).Note: Low Input sensitivity should never be compensated by a high Input gain, as this may cause unwantednoise.Encoding - select the digital audio encoding format to use.Bit rate - depending on the selected encoding, set the required bit rate (audio quality). The higher the bit rate,the greater the bandwidth required.Alarm level - event types in the AXIS 215 PTZ can be set to use this level as a trigger. Each individual eventtype can be configured to trigger if the sound level rises above or falls below the set value.The alarm level can be set in the range 0-100%, where 0% is the most sensitive and 100% the least sensitive.Audio OutputIf the sound from the speaker is too low or high it is possible to adjust the output gain for the connected activespeaker.When satisfied with the settings, click Save, or click Reset to revert to the previously saved settings.16