UL Addendum - Tyco Security Products

More documents

Recommendations

Info

Wiring Relay OutputsThe following diagram shows typical wiring for an AC or DC door lock using the relays oneither the iSTAR panels.Note: Local DC or AC power sources must be power limited, not to exceed the electrical ratingsof the relay.26 C·CURE 800/8000 V9.4 UL Addendum
The following diagram show typical wiring for an AC or DC door lock using the RM4 andARM1 modules.Wiring the apS to an iSTARNote: Battery cables are not power limited and should be isolated from all other cabling by aminimum of ¼ inch. Route these cables away from all other wires.C·CURE 800/8000 V9.4 UL Addendum27
Page 1 and 2: C•CURE 800/8000 System and Compon
Page 3 and 4: OVERVIEWThis addendum provides UL r
Page 5 and 6: SOFTWARE CONFIGURATION REQUIREMENTS
Page 7 and 8: MINIMUM PC CONFIGURATION FOR C•CU
Page 9 and 10: Table 4. Server Requirements - Five
Page 11 and 12: INSTALLATION LOCATIONSThe following
Page 13 and 14: ModelOperatingTemperature(Environme
Page 15 and 16: OPERATIONAL RESTRICTIONSThe followi
Page 17 and 18: FeatureCarpool Anti-passbackArea Mu
Page 19 and 20: RepliStor replicates data from one
Page 21 and 22: Product Code Description Field Repl
Page 23 and 24: Product Code Description Field Repl
Page 25 and 26: Outputs Open collector, +12V DC, 0.
Page 27: Wiring Readers To an iSTARC·CURE 8
Page 31 and 32: Single Device Alarm Zone:Normally O
Page 33 and 34: Single Resistor End Line ModeWiring
Page 35 and 36: iSTAR Backup DatabaseThe software s
Page 37 and 38: Dual End-Of-Line (NC) Configuration
Page 39 and 40: UL LISTED ENCRYPTED LINE SECURITY C
Page 41 and 42: Network ConfigurationThe "UL Listed
Page 43 and 44: PNET1 InstallationPNET1 PhotographC
Page 45: APC Safety• Catastrophic Event Pr

UL Addendum - Tyco Security Products

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?