UL Addendum - Tyco Security Products

More documents

Recommendations

Info

Dual EOL configuration inputs are adapted to the C•CURE 800 system by connecting theseinputs to an I/8 input board, and modifying the effective resistances presented to the board with a12K ohm bias resistor on each input. After the bias resistor is installed, no other specialconfiguration is required to allow Dual EOL inputs to work under full supervision.Bias Resistor12K ohm resistor (0.250 W or larger) is required for each input configured as a 1K / 2K dualtype supervised input.36 C·CURE 800/8000 V9.4 UL Addendum
UL LISTED ENCRYPTED LINE SECURITY CONFIGURATIONConceptual View of NetworkA conceptual view of the UL Listed Encrypted Line Security Configuration is shown in thefollowing diagram "Conceptual View of Campus Network."The head end LAN is isolated from the campus network by a firewall and an encrypting router(Software House Model: 0101-0180-01). Communication from the C•CURE 800 server to theiSTAR Pro panel is through an encrypted VPN tunnel between the two encrypting routers(Software House Model: 0101-0180-01 and Software House Model: 0101-0181-01).The Software House Model 0101-0180-01 and 0101-0181-01 routers have been validated ascorrectly implementing the Advanced Encryption Standard (AES) algorithm, specified in theFederal Information Processing Standard Publication 197 (FIPS 197), Advanced EncryptionStandard.Testing was performed by NVLAP accredited Cryptographic Module Testing (CMT)laboratories using the tests found in The Advanced Encryption Standard Algorithm ValidationSuite (AESAVS).The National Institute of Standards and Technology (NIST) has made every attempt to providecomplete and accurate information about the testing implementations; however, it is theresponsibility of the vendor to notify NIST of any necessary changes to its entry.Conceptual View of Campus NetworkC·CURE 800/8000 V9.4 UL Addendum37
Page 1 and 2: C•CURE 800/8000 System and Compon
Page 3 and 4: OVERVIEWThis addendum provides UL r
Page 5 and 6: SOFTWARE CONFIGURATION REQUIREMENTS
Page 7 and 8: MINIMUM PC CONFIGURATION FOR C•CU
Page 9 and 10: Table 4. Server Requirements - Five
Page 11 and 12: INSTALLATION LOCATIONSThe following
Page 13 and 14: ModelOperatingTemperature(Environme
Page 15 and 16: OPERATIONAL RESTRICTIONSThe followi
Page 17 and 18: FeatureCarpool Anti-passbackArea Mu
Page 19 and 20: RepliStor replicates data from one
Page 21 and 22: Product Code Description Field Repl
Page 23 and 24: Product Code Description Field Repl
Page 25 and 26: Outputs Open collector, +12V DC, 0.
Page 27 and 28: Wiring Readers To an iSTARC·CURE 8
Page 29 and 30: The following diagram show typical
Page 31 and 32: Single Device Alarm Zone:Normally O
Page 33 and 34: Single Resistor End Line ModeWiring
Page 35 and 36: iSTAR Backup DatabaseThe software s
Page 37: Dual End-Of-Line (NC) Configuration
Page 41 and 42: Network ConfigurationThe "UL Listed
Page 43 and 44: PNET1 InstallationPNET1 PhotographC
Page 45: APC Safety• Catastrophic Event Pr

UL Addendum - Tyco Security Products

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?