UL Addendum - Tyco Security Products

More documents

Recommendations

Info

PNET1 Surge Suppressor [2025-0522-01]Safety Precautions• Use only for Ethernet and token ring interface cards, hubs, switches and other LANequipment.• Do not install during a lightning storm! Install in a cool and dry indoor environment.• Turn off power to all equipment to be protected prior to installing the PNet1.The PNet1 mustbe connected to earth ground.• To prevent electric shock when installing the ground wire to the electrical power outletground, turn off electricity to the outlet.• From the electrical panel, switch off the appropriate circuit breaker or remove the fuse forthat circuit/ outlet.InstallationVerify all hardware installation and software configurations before installing the PNet1. Verifythat the system operates correctly with the existing network line.1. Switch off power to the equipment that is to be protected.2. Disconnect the existing network line from the equipment that will be protected.3. Connect this network line to the input jack on the PNet1.4. Connect one end of the supplied 6 inch patch cable to the output jack on the PNet1. This jackis labeled on the PNet1 with a circle and arrow.5. Connect the other end of the patch cable to the input jack on the network equipment that is tobe protected.6. Connect the green/yellow ground wire to ground.Note: To fully protect your system, all surge protectors must be properly grounded. If yourelectrical system is a two- wire non-grounded system, the PNet1 may be left ungrounded.However, please note that if the PNet1 ground wire is not connected to earth ground, thelongitudinal (line to ground) surge protection will be rendered ineffective.40 C·CURE 800/8000 V9.4 UL Addendum
PNET1 InstallationPNET1 PhotographC·CURE 800/8000 V9.4 UL Addendum41
Page 1 and 2: C•CURE 800/8000 System and Compon
Page 3 and 4: OVERVIEWThis addendum provides UL r
Page 5 and 6: SOFTWARE CONFIGURATION REQUIREMENTS
Page 7 and 8: MINIMUM PC CONFIGURATION FOR C•CU
Page 9 and 10: Table 4. Server Requirements - Five
Page 11 and 12: INSTALLATION LOCATIONSThe following
Page 13 and 14: ModelOperatingTemperature(Environme
Page 15 and 16: OPERATIONAL RESTRICTIONSThe followi
Page 17 and 18: FeatureCarpool Anti-passbackArea Mu
Page 19 and 20: RepliStor replicates data from one
Page 21 and 22: Product Code Description Field Repl
Page 23 and 24: Product Code Description Field Repl
Page 25 and 26: Outputs Open collector, +12V DC, 0.
Page 27 and 28: Wiring Readers To an iSTARC·CURE 8
Page 29 and 30: The following diagram show typical
Page 31 and 32: Single Device Alarm Zone:Normally O
Page 33 and 34: Single Resistor End Line ModeWiring
Page 35 and 36: iSTAR Backup DatabaseThe software s
Page 37 and 38: Dual End-Of-Line (NC) Configuration
Page 39 and 40: UL LISTED ENCRYPTED LINE SECURITY C
Page 41: Network ConfigurationThe "UL Listed
Page 45: APC Safety• Catastrophic Event Pr

UL Addendum - Tyco Security Products

Create successful ePaper yourself

Delete template?

Save as template?