1066 Liquid Analytical Transmitter - Emerson Process Management

More documents

Recommendations

Info

MAINMENUCarate1.234µS/cm 25.0ºCCalibrate?1.234µS/cm 25.0ºCSN Calibrate?Free ChlorineTotal ChlorineChloramineOzoneOxygenpHORPRedoxTDSSalinityNaOHHClLow H2SO4High H2SO4NaClResistivityCustom Conc’nConductivity 1.234µS/cm 25.0ºC1.234µS/cm 25.0ºCTemperatureSN Calibrate+025.0°CSN CalibrateCal in progress.Please wait.1.234µS/cm 25.0ºCSN Temp Offset > 5°CContinue?NoYeslibSection 9: CalibrationSeptember 20131066 Instruction ManualLIQ_MAN_1066FIGURE 9-7. Calibrate Temperature96 Calibration
1066 Instruction Manual Section 10: HART CommunicationLIQ_MAN_1066 September 2013Section 10: HART ® Communications10.1IntroductionThe 1066 transmitter can communicate with a HART host using HART Revision 5 or HART Revision7. The revision of HART used by the 1066 can be selected using the keypad/display or a HART mastersuch as AMS or the 475 Handheld Communicator. The default version of HART is Revision 5.Since some HART hosts cannot accommodate HART 7, the choice of HART Revision should bebased on the capabilities of the host, and should be chosen as a first step in configuration. If HARTRevision 7 can be used with the host, it does offer a number of advantages over Revision 5, includinglong tag name, time stamped data, and measurement status, and enhanced burst mode.When HART 5 is chosen, the Device Revision of the 1066 is Device Revision 1; when HART 7 is chosenthe Device Revision is Revision 2 (or greater). The Device Revision of the DD (Device Description)and install files for AMS and DeltaV used should be the same as the Device Revision of the 1066.A single HART 5 (Device Revision 1) or HART 7 (Device Revision 2 or greater) DD (DeviceDescription) is used for all model codes of the 1066, which include the pH/ORP, conductivity, oxygen,chlorine, and ozone transmitters. All 1066 transmitters have the same HART device identification,as outlined below:HART 5 Device Identification (1066 Revision 1):Manufacturer Name: Rosemount Analytical Inc.Model Name: 1066Manufacturer ID: 46 (0x2E)Device Type Code: 33 (0x0021)HART Protocol Revision: 5.1Device Revision: 110.210.2.1HART 7 Device Identification (1066 Revision 2):Manufacturer Name: Rosemount Analytical Inc.Model Name: 56Manufacturer ID: 46 (0x2E)Device Type Code: 11809 (0x2E21)HART Protocol Revision: 7.3Device Revision: 2Physical Installation and ConfigurationHART Wiring and Output ConfigurationHART communications is superimposed on Analog Output 1 for all of the measurements andparameters of the 1066.HART Communications 97
Page 1 and 2:
1066 Liquid AnalyticalTransmitter10
Page 3:
Essential InstructionsRead this pag
Page 7 and 8:
1066 Instruction Manual Table of Co
Page 9 and 10:
1066 Instruction Manual Table of Co
Page 11 and 12:
1066 Instruction Manual Section 1:
Page 13 and 14:
Page 15 and 16:
Page 18 and 19:
Section 2: Description and specific
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Section 3: InstallationSeptember 20
Page 26 and 27:
Section 3: InstallationSeptember 20
Page 28 and 29:
Section 4: WiringSeptember 20131066
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39:
Page 40 and 41:
Section 5: Intrinsically Safe Insta
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Section 6: Display and OperationSep
Page 50 and 51:
Section 6: Display and OperationSep
Page 52 and 53:
Section 7: Transmitter ProgrammingS
Page 54 and 55:
Section 7: Transmitter ProgrammingS
Page 56 and 57: Section 7: Transmitter ProgrammingS
Page 58 and 59: Section 8: Programming Measurements
Page 82 and 83: Section 9: CalibrationSeptember 201
Page 100 and 101: MAINMENUCarate1.234µS/cm 25.0ºCCa
Page 102 and 103: MAINMENUCarate1.234µS/cm 25.0ºCCa
Page 108 and 109: Section 10: HART CommunicationSepte
Page 136 and 137: EC Declaration of ConformitySeptemb
Page 138 and 139: EC Declaration of ConformitySeptemb
Page 140: LIQ_MAN_1066Rev. FSeptember 2013fac
show all

1066 Liquid Analytical Transmitter - Emerson Process Management

Create successful ePaper yourself

Delete template?

Save as template?