1066 Liquid Analytical Transmitter - Emerson Process Management

Section 8: Programming MeasurementsSeptember 20131066 Instruction ManualLIQ_MAN_10668.28.2.1pH Measurement ProgrammingDescriptionThe section describes how to configure the 1066 transmitter for pH measurements. The followingprogramming and configuration functions are covered.1. Measurement type: pH Select pH, ORP, Redox.2. Preamp location: Transmitter Identify preamp location (automatic detection for SMART pHsensors)3. Filter: 4 sec Override the default input filter, enter 0-999 seconds4. Reference Z: Low Select low or high reference impedance5. Resolution: 0.01pH Select 0.01pH or 0.1pH for pH display resolutionTo configure pH:1. Press MENU1.234µS/cm 25.0ºCSN Configure2. Scroll down to Program. Press ENTER.Measure: pHPreamp: Analyzer3. Scroll down to Measurement. Press ENTER.Sol’n Temp Corr: OffThe adjacent screen format will appear (factory defaults are shown).Resolution: 0.01pHTo program any function, scroll to the desired item and press ENTER. Filter: 4 secReference Z: LowThe following sub-sections provide you with the initial display screen that appears for each configurationfunction. Use the flow diagram for pH programming and the 1066 live screen promptsfor each function to complete configuration and programming.8.2.2MeasurementThe display screen for selecting the measurement is shown. The defaultvalue is displayed in bold type. Refer to the pH/ORP Programming flowdiagram to complete this function.1.234µS/cm 25.0ºCSN MeasurementpHORPRedox8.2.3PreampThe display screen for identifying the Preamp location is shown. Thedefault value is displayed in bold type. Refer to the pH/ORPProgramming flow diagram to complete this function.Note: Sensor/JBox must be selected to support SMART pH sensors fromRosemount Analytical.1.234µS/cm 25.0ºCSN PreampAnalyzerSensor/JBox48 Programming Measurements