13.3” LOW VOLTAGE BedMate II DTV Operations Manual - Hci

----------------------------------------------------------------------------------BedMate II OPERATIONS MANUAL
Ch No Turn On channel. Set will turn on to this channel. Set to 0 to turn on to channel TV was
ON on when turned off. Input Source should be set to TV.
Volume Turn on volume setting. Set to zero to turn on to same volume level when set was turned
On off.
IR Band Sets IR band to use. See page 27. Selections are:
Off - Band 1 – Band 2 – Band 3 – Band 4
PowerOn Power control settings. Selections are:
Mode
OFF – Mode 1 – Mode 2 – Mode 3
OFF Normal power on/off operation
Mode 1 Power on with power. Set turns on when power is applied and can only
be turned off by removing power.
Mode 2 Power on with power. Set can be turned off without removing power.
Mode 3 Power on with power only. Sets come on with power and can be turn
off. Power must be removed to turn back on.
LED Ctrl Power LED operation. Selections are:
NORMAL – Reverse – OFF-ALL – OFF-BLK
NORMAL Power LED is on when TV is on.
Reverse Power LED is on when TV if off
OFF-ALL Power LED is always off.
OFF-BLK Power LED is always off but blinks when IR remote control is used
or keypad button is pressed.
KeyPad Lock Locks the front panel buttons. Selections are:
Off – Lock 1 – Lock 2
Off All buttons function.
Lock 1 Only POWER button functions.
Lock 2 Only POWER, VOL+, VOL-, CH+ and CH- buttons function.
¼ inch Sets operating mode of the pillow speaker jack. Selections are:
Pillowspeaker
Zenith – Puff-slip – Visitor Station – GEN4_R5 – GEN4_INTER – Philips
Zenith Pillow speakers sending Zenith digital code.
Puff-slip Sip and Puff device.
Visitor Station HCI Visitor Station
GEN4_R5 Curbell GEN 4 Pillow Speaker
GEN4_INTER HCI interactive pillow speaker
Philips Pillow speakers sending Philips digital code.
HealthCare Information, LLC 25